Product Information; Description; Specifications - red lion RBSS-75FC El Manual Del Propietario

PRODUCT INFORMATION

Description

This water pressure boosting system consists of an inline control device attached to a 2-stage booster
pump. The control activates the pump to provide strong, even water pressure when multiple water fixtures
are in use. Once the water flow stops, the control turns off the pump.
The booster system is designed to work in homes with a municipal water
source, or a cistern. It is not designed for systems using a well.
Please examine the pump carefully to ensure that no damage occurred
during shipment. If damage has occurred, please contact the place of pur-
chase. They will assist you in replacement or repair, if required.
Features
Configuration
• Simple set up with no programming or adjustment necessary on the
equipment
• No additional pressurized bladder tank or pressure switch needed
Inline Control
• Flow based pump activation
• Run Dry protection
• Automatic system reset/restart after a power loss or an out-of-water event.
Operation
• Control has LED indicators for system status and troubleshooting
• Manual Reset pushbutton can be used to start the pump at any time.
This product is covered by a Limited Warranty for a period of 24 months from the date of original purchase
by the consumer. For complete warranty information, refer to www.redlionproducts.com; or, call Technical
Support for a printed copy.

Specifications

Booster Pump with Flow Control
Enclosure Type
Motor Size and Voltage
Max Current
Impulse Voltage
Acceptable Voltage Fluctuation
Frequency
Overload Protection
Max Operating Pressure
Max Pump Case Pressure
TEFC, NEMA Type 4
0.75 hp 0.55 kW 115 V
9.0 A
2.5 kV
±10%
60 Hz
302 °F (150 °C)
46 psi (3.2 bar)
91 psi (6.3 bar)
Nominal Fluid Temperature
Max Fluid Temperature
Max Ambient Temperature
Intake Connections
Discharge Connection
Seal Type
Internal Protection
Minimum Flow
PRODUCT INFORMATION
Description
68 °F (20 °C)
100 °F (37.8 °C)
104 °F (40 °C)
1" FNPT
1" MNPT
Mechanical Seal and O-ring
Pollution Degree 2
0.13 gpm
3