Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
RISER SCREENS (H-5242, H-5243)
NOTE: Riser is required to meet California OSHA
regulations.
Figure 3
Riser
Back
Screen
PAGE 3 OF 9
ACCESSORIES CONTINUED
Support Arm
A
B
Clamp
1-800-295-5510
uline.com
1. Align riser with back screen. Attach with three
5/16-18 x 3/4" bolts, washers and locknuts.
(See Figure 3A)
2. Attach support arms to inside of riser with
two 5/16-18 x 1½" bolts, washers and locknuts.
Extend the support arms. (See Figure 3)
3. Attach clamp to guardrail tube where support arm is
fully extended. Thread arm through clamp using two
5/16-18 x 1½" bolts, washers and locknuts. Tighten.
Repeat with other support arm. (See Figure 3B)
NOTE: May need pliers to adjust clamps.
NOTE: Ensure riser is completely upright when
attaching the clamp and support arms.
Hardware Included
Clamp x 2
5/16-18 x 1½" Bolt x 4
Washer x 7
Locknut x 7
5/16-18 x 3/4" Bolt x 3
0920 IH-2771
Publicidad
Tabla de contenido
