Parkside PDSSA 12 A1 Traducción Del Manual De Instrucciones Original página 42

Battery pack: PAP 12 A2
Type:
Rated voltage:
Cells:
Capacity:
High-speed battery charger: PLG 12 A2
INPUT:
Rated voltage:
Power consumption:
OUTPUT:
Rated voltage:
Rated current:
Charging time:
Fuse (internal):
Protection class:
Noise emission value:
Noise measurement value determined in accordance
with EN 60745. The A-rated noise level of the
power tool is typically as follows:
Sound pressure level:
Uncertainty K:
Sound power level:
Uncertainty K:
Vibration emission value:
Total vibration values (vector total of three direc-
tions) determined in accordance with EN 60745:
Tightening screws and nuts of maximum permissible
size:
a = 6.9 m/s 2
h
Uncertainty K = 1.5 m/s
Wear ear protectors!
PDSSA 12 A1
LITHIUM ION
(DC)
12 V
3
2000 mAh
230–240 V ~ (AC), 50 Hz
38 W
(DC)
12.6 V
2.4 A
approx. 60 min
T2A
2 A
II / (double insulation)
L = 90 dB (A)
PA
K = 3 dB
PA
L = 101 dB (A)
WA
K = 3 dB
WA
2
NOTE
► The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure and
can be used for equipment comparisons. The
specified vibration emission value can also
be used to make an initial exposure estimate.
WARNING!
► The vibration level varies depending on the
use of the power tool and may, in some cases,
be higher than the value specified in these
instructions. Regular use of the power tool in
this way may cause the user to underestimate
the vibration. Try to keep the vibration loads
as low as possible. Measures to reduce the
vibration load are, e.g. wearing gloves and
limiting the working time. Wherein all states of
operation must be included (e.g. times when
the power tool is switched off and times where
the power tool is switched on but running
without load).
GB │ MT │
39 ■