Attaching The Fan Blades - HAMPTON BAY 705 544 Manual Del Propietário

CLOSE-TO-CEILING MOUNTING
1. Carefully unhook the fan from the mount-
ing bracket and align the locking slots of
the ceiling canopy with the two screws in
the mounting plate. Push up to engage the
slots and turn clockwise to lock in place. Im-
mediately tighten the two mounting screws
firmly.
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING.
DO NOT LEAVE FAN ASSEMBLY UNATTENDED
UNTIL ALL FOUR CANOPY SCREWS ARE EN-
GAGED AND FIRMLY TIGHTENED.
2. Install the remaining two mounting screws
into the holes in the canopy and tighten
firmly.
3. Install the decorative canopy ring by align-
ing the ring's slots with the screws in the
canopy. Rotate the ring clockwise to lock in
place.
4. You may now proceed to attaching the fan
blades.
8.
Attaching the
Fan Blades
1. Attach blade to blade bracket using the
screws as shown in figure 14. Please note that
the rubber washers are pre-attached to the
blade bracket. Start a screw into the bracket.
Repeat for the two remaining screws
Screws
Pre-Installed
Screws
Rubber
Blade
Washers
Bracket
REMOVE RUBBER STOPPERS ON THE BLACK
PLATE BELOW THE MOTOR TO ATTACH BLADE
ASSEMBLY TO MOTOR. REPLACE RUBBER
STOPPERS TO PREVENT WATER FROM ENTER-
ING SWITCH HOUSING AND TO REDUCE RISK
OF FIRE, ELECTRIC SHOCK OR OTHER PER-
SONAL INJURY.
2. Tighten each screw securely.
3. Fasten the blade assembly to the motor by
inserting the alignment post into the slot on
the bottom of the motor and tightening the
blade bracket screws. Please note that the
blade bracket screws are pre-installed into
the blade bracket (Figure 15).
4. Repeat steps 1-3 for the remaining blades.
Blade
Attaching the
Figure 14
Switch Housing
1. Connect the adaptor plug exiting the bottom
of the motor with the plug from the switch
housing.
2. Mount the switch housing to the black plate
below the motor by aligning the four screw
holes and securing with the four tapered
screws provided.
Slot
Alignment Post
Blade Bracket
Screw
Figure 15