Handle Attachment - Black and Decker Price Pfister 808 Serie Manual Del Usuario

6 TRIM FLANGE ATTACHMENT
NOTE: Trim Flange attachment procedures for both trim flange types
(6A) are to be identical.
Position Flange (6A) on Valve (6B) with Drain Hole (6C) at the bottom. Place
Protective Washer (6D) on the short end of the reversible Retainer Sleeve
(6E). Screw Retainer Sleeve (6E) onto threaded section of the Stem and
Bonnet (6F). Tighten Retainer Sleeve (6E) by hand until Flange (6A) is snug
to finished wall surface. If the short end of the Retainer Sleeve (6E) is too
short, reverse it to use the longer end.
7
7T
7C
7A
7D
7E
7F
7G
7V
7H
7K
7L
7M
7N
7K
7P
7M
7N
7R
7Q
7B
ROUND ACRYLIC HANDLE
7B
7Q
LOOP LEVER HANDLE
7B
7Q
PARISA LEVER HANDLE
7B
7Q
LEVER HANDLE
ENGLISH

7 HANDLE ATTACHMENT

.
NOTE: Handle attachment procedures are to be identical for both
flange types (7Q) and (7R).
Round Acrylic Handle:
With valve in "CLOSED" position, place Handle (7A) onto Valve Stem (7B) and
turn Handle (7A) until it stops. Check that the Semi Circular Notch (7T) in front
of Handle (7A) is pointing upward. Tighten Handle (7A) to Valve Stem (7B) with
.
Screw (7D). Position RED/BLUE Ring (7C) on Button (7E) and align with the
Semi Circular Notch in Handle (7T), then press on.
Loop Lever Handle:
With valve in "CLOSED" position, attach Handle (7F) onto Valve Stem (7B).
.
Secure with Screw (7G). Attach Label (7V) to Button (7H), "Red Arrow" on
Pressure Balancer. Press Button (7H) into Handle (7F) hole.
Parisa Lever Handle:
With valve in "CLOSED" position, screw Stem Adaptor (7K) into Valve Stem
(7B). Attach Parisa Lever Handle (7L) onto Stem Adaptor (7K) and Valve
.
Stem (7B), then secure with Set Screw (7M), using the provided 3/32" Allan
Wrench (7N).
Lever Handle:
With valve in "CLOSED" position, screw Stem Adaptor (7K) into Valve Stem
(7B). Attach Lever Handle (7P) onto Stem Adaptor (7K) and Valve Stem (7B),
then secure with Set Screw (7M), using the provided 3/32" Allan Wrench (7N).
Make sure Set Screw (7M) is securely tightened to handles (7L) and (7P).
8
8A
8 SHOWER ARM INSTALLATION
Insert the longer end of Shower Arm (8A) through the Shower Flange (8B).
Apply PTFE plumber's tape to both ends of Shower Arm (8A) according to
manufacturer's instructions. Screw the end of Shower Arm (8A) into pipe elbow
inside the wall. Slide Shower Flange (8B) tight to the wall.
3
8B