Measuring Procedure - Tenker U80EH Manual De Instrucciones

Proper use of the unit
Measuring procedure：
Aſter the cuff has been appropriately positioned, the
measurement can begin：
1. Press the START/STOP button, all symbols appear on the
display, you can hear 2 short beep aſter 0 flash for 2 seconds,
then the pump begins to inflate the cuff, the rising pressure
in the cuff is shown on the display.
2. Aſter the suitable pressure has been reached, the pump
stops and the pressure gradually falls. The cuff pressure is
displayed. In case that the inflation is not sufficient, the device
automatically re-inflates to a higher pressure.
3. When the device detects the signal, the heart symbol on
the display starts to flash, you can hear the beep for every
heartbeat once the heartbeat signal is detected.
4. When the measurement has been completed, you can hear a long beep, in
the meantime, the systolic, diastolic and pulse rate will appear on the display.
5. The measurement readings remain on the display until you switch off the
device. If no button is pressed for a period of 3 minutes, the device switches
off itself in order to save the power.
13