Specifications; Unpacking The Unit - Dimplex Revillusion RBF24DLX El Manual Del Propietario

Specifications

The Revillusion™ Electric Fireplace offers an alternative to a wood or gas
fireplace. It can give your existing fireplace new life or transform a cabinet or
media center of your own into a stunning focal point.
Electrical
120 V
Volts
60 Hz
11.25 A @ 25
Amps
12.50 A @ 0
1350 W @ 25
Watts
1500 W @ 0
Plug-in fireplace,
Wiring
hard wire optional
Bulb Type LED
Approvals
Dimensions
RBF24DLX
24 ¼"
Width
640 mm
22 ⅞"
Height
581 mm
12 ⅛"
Depth
307 mm
Operation Temperature
-4 to 104
o
WARNING: Electrical outlet wiring
must comply with local building
codes and other applicable
regulations to reduce the risk of
fire, electric shock, or injury to
persons.
6
o C
o
C
o C
o C
RBF24DLXWC
24 ¼"
640 mm
22 ⅞"
581 mm
12 ⅛"
307 mm
F (-20 to 40 C)
o o o
!
NOTE: A 15 Amp circuit is required.
A dedicated circuit is preferred,
but not essential in all cases. A
dedicated circuit will be required if,
after installation, the circuit breaker
trips or the fuse blows on a regular
basis when the heater is operating.
Additional appliances on the same
circuit may exceed the current rating
of the circuit breaker.

Unpacking the Unit

The unit comes packed with a
protective sheet covering the front
of the unit. This sheet is intended to
prevent dust and debris from entering
during construction. This sheet is
designed so that it can be partially
removed to complete the wiring and
unpacking and can be reinstalled until
the final installation is complete.
The log set was installed on the grate
and the grate permanently fixed to the
fireplace at the factory.
Carefully remove the packaging from
around the log set. Make sure the wires
from the log set are connected securely
to the grate box.
CAUTION: The Realogs
LEDs to create a unique pulse
and glow effect. Handle the log set
carefully. They are fragile and can
crack or break if dropped.
contain
®
www.dimplex.com