Usage; Initial Start-Up; Check Blender And Delivery; Basic Cleaning - Exquisit MU 3002 we Manual De Instrucciones

11 Usage

The unit is exclusively designed for
mixing. The blender is intended solely for
private use and not for commercial use.
Use the blender just as described in this
manual. Any other use is considered
improper and can result in property
damage or even personal injury.
The manufacturer or dealer will not accept
liability for damage caused by improper or
incorrect use.

12 Initial start-up

12.1 Check blender and delivery

If you open the package carelessly with a
sharp knife or other pointed object, the
blender can be easily damaged.
Be very careful when opening.
The blender is protected from damage
during transport by the packaging.
1. Take the blender from the packaging.
2. Check that the blender or the
installation parts have damage.
3. If this is the case, do not use the
blender. Contact our specified service
centre.
4. Check whether the delivery is
complete.

12.2 Basic cleaning

1. Remove the packaging materials, and
protective films.
2. Clean all the parts of the blenderd
before the first use as described in
"Cleaning".

12.3 Set up blender

WARNING
If you place the blender improperly, it
•
can cause damage.
Place the blender on a flat, dry and
•
non-slip work surface. The work area
should be easy to clean, since you can
not always prevent splatter.
Don't place the blender on or near the
edge of the working surface.
Never place the blender on or near hot
surfaces (eg. hobs, heating pipes, etc.).
Note that the surface coatings of
furnitures sometimes contain chemical
additives which affect and soften the
suction cups of the blender. In this way,
residues can arise on the furniture
surfaces. Therefore, place a non-slip
surface under the blender.
The drive unit 5 is equipped with suction
cups which provide a secure grip for the
blender.
Set the blender up that it is easily
accessible and near a power outlet.

12.4 Compose blender

Improper handling of the blender or
individual instruments can cause serious
injury.
Turn the blender off, and remove the plug
from the socket when you assemble or
disassemble the blender.
The blender has two safety devices. It can
only be used with a properly attached
mixing bowl and properly attached safety
covers.
The mixing container 3 is marked at the
lower end with a triangle. On the drive
unit 7 is an open and a closed lock
illustrated.
1. Place the jug on the drive unit so that
the triangle on the jug points to the
open lock.
2. Turn the jug clockwise until the
triangle points to the closed lock. Hold
the drive unit. It will be heard and felt
when the mixing bowl locks.
3. Place the safety cover 2 on the jug so
that the long edge, looked from the
handle, is placed to the right of the
handle.
4. Turn the safety cover clockwise until it
stops.
5. The long lead is now under control.
6. Put the lid insert 1 in the filling
opening, so that the two lugs fit into
the recesses in the filling opening on
the lid and fix the lid insert by rotating
clockwise till it stops.
7. You have successfully assembled the
blender jug
EN
Seite | 15