Operating Instructions; Adjust Speed; Use Blender - Exquisit MU 3002 we Manual De Instrucciones

EN

13 Operating instructions

WARNING
Improper handling of the blender or
•
individual instruments can cause
serious injury. Do not touch the knife
with bare hands, the blades are very
sharp.
Do not remove the safety cap until the
•
blades have completely stopped.
Do not change the location of the
•
blender while the blender is running.
Make sure that hands, hair, clothing,
jewelry or another object during the
mixing process, and as long as the mixing
container is located on the drive unit, are
not getting in the jug. Always make sure
that the speed controller is at level "0"
(off) before connecting the blender to a
socket.
WARNING
When processing hot mixing goods, it can
cause scalding.
Do not put hot or boiling mixing goods
(such as soups) in the jug.
WARNING
• Improper handling of the blender can
lead to damage
of the blender.
Take note of the level marks. Fill the
•
mixing bowl at least to the lowermost
mark (250 ml) and do not exceed the
"MAX" (1500 ml) mark.
Do not operate the blender without
•
mixing goods.
Observe the maximum operating time
•
of 60 seconds.
• A too long operating time can lead to
overheating of the engine. Allow the
blender to cool on room temperature
before using it again
Before turning on the blender, make
•
sure no cutlery or the like is in the
mixing bowl.
• Do not place over-sized pieces in the
blender jug.
• Make sure when you use frozen fruit
that you always use the fruit in small
pieces.
Do not mix nuts in shell or seeds.
•
Seite | 16
Always remove any existing stems or
•
stalks from mixing goods before you
start the mixing process.
• Do not place meat in the blender.
Never open the safety cover during
•
the mixing process.
Clean the mixing bowl after each use
•
as described in "Cleaning".

13.1 Adjust speed

The speed control is used to select
between two speed levels "1" and "2" a
pulse level "P" as well as to turn off the
blender, level "0".
Start the mixing process at the lowest
•
speed "1".
Later set the speed on the higher
•
level.
• You turn off the blender, if you set the
speed control to the "0" level.
• If you set the speed control to the
pulse level "P", you are using the pulse
function. Refer to the section "Pulse
function".

13.2 Use blender

To facilitate the handling of the blender,
the blender container 3 is provided with
level markings. The numbers indicated
there refer to the respective level in
milliliters. The lowest mark has no level
indication. It corresponds to a level of 250
ml.
1. Operate the blender with at least 250
ml of liquid.
2. Do not fill more liquid in the blender as
the 1500 ml mark "MAX".
3. Always cut solid ingredients before
adding it in the bowl in small pieces so
you prevent jamming of the knives. If
you want to process solid and liquid
ingredients to the blender at the same
time, first enter the liquid ingredients
into the mixing bowl and mix the
ingredients.
Then enter the solid, finely chopped
ingredients, and continue the mixing
process. In order to obtain the structure
of the food, it is best to do the mixing
process in a few seconds.