Stanley PAC GS3-LF Guia De Instalacion página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 19
English
English
Installation
1. Ensure your product comes with the items indicated on page 4; if not please contact
your dealer.
2. Drill a 1 ⁄ 2" or 13mm diameter hole for the tamper magnet — see page 4.
3. Push the tamper plug into the hole, then insert the tamper magnet.
4. Drill a 13 ⁄ 32" or 10mm diameter hole for the flying lead — see page 4.
5. Connect the flying lead — see page 5.
6. Set output format — see page 6.
7. Configure reader — see page 9.
8. Use the supplied vandal resistant screws to attach the reader to the wall. These require
a special screwdriver (P/N 1950), available separately.
9. Apply power when all readers are installed.
Notes
If power is applied when the tamper magnet is not positioned correctly, a reader
tamper condition is generated and the reader beeps.
Mount readers >3' / 1m apart, e.g. on either side of the door. Mounting on metal
surfaces will reduce the reading range.
If the reader is being used to enter credential information to arm a system, the
reader must be located within 3' / 1m of the panel's main keypad or display.
For outside readers, use corrosion-resistant fixings and apply silicone sealant to
the backplate before fixing to the wall.
The supplied MOV (Metal Oxide Varistor, Anglia Components P/N B72207S250K101)
should be fitted across the power terminals of the lock to suppress back EMF. Any
suppression diodes fitted in the lock / lock circuit must be removed.
Output format and reader configuration can be changed without disconnecting the
power supply. The reader automatically restarts with the new configuration.
10

Publicidad

Tabla de contenido
loading

Tabla de contenido