TCL 6W3ER1-A Manual De Instrucciones página 10

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

room temperature rises above the user-set temperature. While in ECO mode the fan will
occasionally turn on for a few seconds in order to take a accurate temperature reading.
• Fan Mode – press the MODE button on the panel or the Fan Only button on the remote.
This Fan Only mode only works when the air conditioner is vented.
• Fan Speed – press the FAN SPEED button on the panel or the Fan Speed button on the
remote - Press the FAN SPEED button to choose the fan speed options. You can choose Hi,
Med, Lo or auto speed in COOL mode and choose Hi, Med, Lo in FAN mode.
• Dry Mode – available only by pressing MODE button on the panel - This function reduces
the humidity of the air to make the room more comfortable. Press the MODE button to set
the DRY mode. An automatic function of alternating cooling cycles and air fan is activated.
5.
Timer Button – press the TIMER button on the panel or the Timer button on the remote to set
the timer.
• Set Timer On: With the AC off, press the Timer button and then use the
buttons to set the desired temperature. Press the Timer button again and use the
and
timer button again to start the countdown.
• Set Timer Off: With the AC on, press the Timer button and then use the
buttons to set the length of time before the AC will turn off. Press the timer button again to
start the countdown.
Note: It can be set to automatically turn off or on in 0.5-24 hours. Each press of the buttons will
increase or decrease the timer. The Timer can be set in 0.5 hours increment below 10 hours and
1 hour increments for 10 hours or above.
The SET light will turn on while setting. To cancel the set function, press the TIMER button again.
6.
Sleep Button – press the SLEEP button on the panel or the Sleep on the remote – by doing
so, all of the display lights will turn off after a while, but the Sleep light is always on. In SLEEP
mode, the air conditioner will automatically adjust the temperature and fan speed to make the
room more comfortable during the night. The set temperature will automatically raise every
30-60 minutes, and at most change six times until the set temperature is 81 or 82 degrees.
7.
Filter Button – After the fan motor runs for 500 total hours, the Filter Check light will turn on
to remind the user to clean the filter. After you clean the filter, you can turn off the light by
pressing the Filter button.
Normal Operating Sounds
You may hear a pinging noise, caused by the water hitting the condenser on rainy days, or when
the humidity is high. This design feature helps remove moisture and increase efficiency.
You may hear the thermostat click when the compressor cycles on and off. Water will collect in the
base pan on rainy days, or high humidity days. The water may overflow and drip from the unit on
the outside. The fan may run, even when the compressor is not on.
buttons to set the desired amount of time before the AC turns on. Press the
9
and
and

Hide quick links:

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido