General Maintenance - EGO POWER NEXUS ESCAPE PAD1500E Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
2. Connect the small USB or AC device to the power
inverter.
3. Press and hold the power button until the green light
in the button illuminates. The power inverter will
begin charging the device.
4. When not using or after charging, disconnect the
device from the power inverter, then press and hold
the power button until the green light turns off.
5. Hold the battery pack with one hand and pull the
power inverter with the other hand to separate them.
WARNING:
Do not insert a nail, wire, etc. into the AC
power supply port, or the risk of electric shock may occur.
NOTE:
The product may not supply power to some USB
devices.
Do not insert a nail, wire, etc. into the USB power
supply port. Otherwise a circuit short may cause
smoke and fire.
If the devices connected to the power inverter draw
more than the rated output of the ports (Total 4.2A for
USB ports and maximum 150W for AC port), the power
inverter will shut off automatically and the power
button will flash red. In this situation, devices should be
removed. To reactivate the power inverter, press and
hold the power button until green light is illuminated.
When switching on the power inverter, if the USB
output current is less than 500mA and the AC output
power is less than 5W, the system will shut off
automatically in 1 minute.
When switching on the power inverter, if the USB
output current is beyond 500mA or the AC output
power is beyond 5W, but then the USB output current
is less than 500mA and the AC output is less than 5W
for 3 hours, the system will shut off automatically.
MAINTENANCE
WARNING:
To avoid serious personal injury, always
remove the battery pack from the tool when cleaning or
performing any maintenance.
WARNING:
When servicing, use only identical EGO
replacement parts. Use of any other parts may create a
hazard or cause product damage.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids,
gasoline, petroleum-based products, penetrating oils,
etc. come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in
serious personal injury.
STORING THE UNIT
Remove the battery pack from the power inverter.
Clean the tool thoroughly before storing it.
Store the unit in a dry, well-ventilated area, locked-up
or up high, out of the reach of children. Do not store
the unit on or adjacent to fertilizers, gasoline, or other
chemicals.
Protecting the environment
Do not dispose of electrical equipment,
used battery and charger into household
waste! Take this product to an authorized
recycler and make it available for separate
collection. Electric tools must be returned
to an environmentally compatible
recycling facility.
56 VOLT POWER INVERTER — PAD1500E
EN
5

Publicidad

Tabla de contenido
loading

Tabla de contenido