Maintenance And Troubleshooting - Performax SKU 240-2972 Instrucciones De Operación Y Seguridad

drum could cause the work piece to fly up and
result in an injury.
2) Always sand outside curves on the left hand
side of the sanding disc. (SEE FIG.M2)
WARNING: Applying the workpiece to
the right side of the disc could cause
workpiece to fly up (kickback) and result in injury.
M1
M2
Maintain tools with
care
Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working
controls free of dust. If you see some sparks
flashing in the ventilation slots, this is normal and
will not damage your power tool.
If the supply cord is damaged, it must be replaced
by a special cord or assembly available from the
manufacturer or its service agent.
12
Maintenance and
Troubleshooting
Troubleshooting
Although your new Belt / Disc sander is really very
simple to operate, if you do experience problems,
check the following:
1. Belt / Disc sander
Check that there is "mains" at the socket; test
with an electrical screwdriver or another electrical
appliance; check the connections in the plug;
correct and tighten poor connections; check the
fuse; if suspect replace with correct rating fuse.
2. Wheel wobbles or vibrates
Check that the lock nut is tight. Check that the
wheel is correctly located on the shaft and
locating washer. If excessive pressure has
been used or the wheel has "caught", it may be
damaged causing it to vibrate. If there is any
evidence that the wheel is damaged, DO NOT
USE, remove it and replace with a new wheel.
Dispose of old wheels sensibly.
Handy hints
Your Belt / Disc sander is useful for wooden work
pieces. However this is not a heavy duty tool and
is designed primarily for light home and hobby
use.
At all times, do not force it or apply excessive
pressure to the wheel.
Try to use the tool rest for supporting and guiding
the workpiece.