Performax SKU 240-2972 Instrucciones De Operación Y Seguridad página 8

Operation instructions
NOTE: Before using the tool, read the
instruction book carefully.
ASSEMBLY
WARNING: Remove the plug from
the socket before carrying out any
adjustment, servicing or maintenance.
1. MOUNTING THE BELT/DISC SANDER TO
WORKBENCH (SEE FIG.A)
If belt/disc sander is to be used in a permanent
location, it should be fastened securely to a firm
supporting surface such as a workbench.
If mounting to a workbench, holes should
be drilled through supporting surface of the
workbench.
1) The unit should be bolted securely using
M8 screws and hex nuts (not provided). Screw
length should be about 1.5" plus the thickness
of the bench top.
2) Locate and mark the holes where belt/disc
sander is to be mounted.
3) Drill 2 holes of 0.4" diameter though
workbench.
4) Place belt/disc sander on workbench aligning
holes drilled in workbench.
5) Insert two M8 screws and tighten hex nuts.
A
2. ASSEMBLING SANDING DISC AND
GUARD (SEE FIG.B1-B3)
1) Remove the backing from the sanding disc
(6). Align perimeter of disc with sanding plate
(3) and press disc firmly into position all the way
around.
2) Locate disc guard (a) and two M4.2 pan head
screws.
8
3) Position disc guard against lower 1/3 of disc,
aligning holes.
4) Using a Phillips screwdriver, fasten the pan
head screws securely, applying light pressure to
thread the holes.
6
B1
3
B2
a
B3
3. INSTALLING WORK SUPPORT (SEE
FIG.C)
1) Adjust the work support hex screw (13) on
side of belt/disc sander by using an allen key.
2) Hold work support in position and fasten.