Installation
. Undo the securing screws from the housing unit and open the back of
the enclosure by sliding the tray out of the aluminum housing.
Note the IDE / SATA connector for the 2.5" HDD.
2. Place the HDD on the tray, line-up the connectors with the drive and
gently insert the HDD into the tray's connector until the connection is
secure.
• 2.5" SATA HDD
• 2.5" IDE HDD
2
HDD Installation
IDE Connector
SATA Connector
. While supporting the HDD with your hand, gently turn the tray over
and locate the HDD mounting holes. Use the four (4) mounting screws
(provided) to secure the HDD to the tray.
4. Gently insert the tray back into the housing until the back panel
fits against the housing.
5. Secure the back panel to the housing using the screws provided.
.
HDD Installation