Lutron Homeworks HR-CCI-6-SW Instrucciones De Montaje

Installation Instructions
Please Read Before Installing
Overview
The RF Contact Closure Input Interface (HR-CCI-6-
SW) allows the HomeWorks lighting control system to
seamlessly integrate with other manufacturers' contact
closure outputs. The RF CCI Interface may be conve-
niently located close to the controlling equipment,
because it wirelessly communicates with the
HomeWorks lighting system. This provides simple,
reliable and flexible whole-home integration.
Up to 32 interfaces or keypads, each with a unique
address, can be assigned to each HomeWorks RF
Processor.
Important Notes
Codes: Install in accordance with all local and nation-
al electrical codes.
Power: Use only the adapter provided by Lutron with
your unit (Lutron model # T120-9DC-3-WH).
Caution - Using an adapter not rated at the
following specifications could damage the
RF CCI Interface and possibly overheat the
adapter.
• Input: 120/127 V
• Output: 9 V /300 mA Class 2
Contact Closure Compatibility: The input closures
are intended for use with devices that provide main-
tained or momentary outputs in the form of dry contact
closure or open collector outputs meeting the follow-
ing criteria:
• On saturation voltage: < 1.0 V
• Off leakage current: < 10.0 µA at 12 V
• Outputs must stay in the closed or open
state for at least 40 msec in order to be rec-
ognized by the interface
If there is any question as to whether the contact clo-
sure device is compatible with these specifications,
contact the manufacturer of that device.
Contact Closure Wiring:
Caution - DO NOT apply voltage between
any two terminals on the RF CCI Interface.
This will cause improper operation and could
damage the interface and the connected
equipment.
50/60Hz
at 2 mA
RF Contact Closure Input Interface
HR-CCI-6-SW
120/127 V , 50/60 Hz (9 V adapter)
HR-CCI-6-SW
Environment: Ambient operating temperature:
32-104°F (0-40°C), 0-90% humidity, non-condensing.
Indoor use only.
Cleaning: To clean, wipe with a clean damp cloth. DO
NOT use any chemical solutions. Do not paint the RF
CCI Interface.
RF Device Placement: RF CCI Interfaces must be
located within 30 feet (9m) of an RF Signal Repeater
or an RF Processor (see System Communication,
page 3).
1