EN
without using the lap belt.
ASSEMBLY AND USE INSTRUCTIONS
1. Follow the 1 arrow direction to open the latch. Then follow the 2
arrow direction to lift and flung the stroller to open it.
2. See picture 2, this is how it fully open.
3. Follow the arrow direction to plug the wheel bearing into the
wheel housing.
4. See jig A, follow the arrow direction to plug the rear wheel into
wheel housing, and finish rear wheel assemble. See jig B, press
the rear wheel detach button and pull the wheel out in order to
detach the rear wheel.
5. See picture 5, follow the arrow direction to press the brake
button to brake the stroller.
6. See picture 6, lift the brake button to release the brake.
7. See picture 7, pull the button up as the 1 arrow direction to lock
the swivel wheel. To push down as 2 arrow direction to release
the swivel wheel.
8. See pictures 8, as the picture shows, plug the front bumper bar
both side into the hole to assemble the front bumper bar.
9. See picture 9, Right-hand follow 1 arrow direction to lift ou-
tward, Left-hand pull the front bumper bar out follow 2 arrow
14
direction to detach the front bumper bar.
10. If it is two position back rest, adjust the backrest position as
10a picture.
11. If it is multiply backrest position, adjust the backrest position
as 10b picture. Lefthand squeeze and press the button,and
righthand full the D ring to adjust the backrest position.
12. See picture 11, follow 1 arrow direction to move the canopy
forward or backward.
LOCKING THE FOOTREST
13. Lift the folding latch follow the 2 arrow direction can fold the
handle bar, see how it is as picture 13.
14. See picture 14, Right-hand forefinger press the red second
lock button, the rest three fingers lift the folding button follow
2 arrow direction. Meanwhile, follow 3 arrow direction to pull
back to fold the stroller.
15. See picture 15, follow arrow direction to snap the lock to lock
the stroller. Release the lock to open stroller.
16. See picture, once lock the stroller, you can carry the stroller like
the picture.
17. ADJUST THE SEAT BELTS TO FIT THE CHILDREN WHENEVER
THEY USE THE PUSHCHAIR. The two side fastening points of
the seats can be used to at-tach an additional harness. Your
pushchair is approved for new born babies. To fit the belts on
your baby when he is under 6 months old, pass the shoulder
straps through the lower holes and fasten the shoul-der
1/7/18 8:26