Publicidad
V5019
3
A. Move lever to lock
B. Swivel
A. Zwecks Verriegelung
Hebel bewegen
B. Schwenken
A. Mover la palanca para
bloquear
B. Basculante
A. Abaisser le levier
pour verrouiller
B. Faire pivoter
4
2
A
B
DK
A. Tryk for at låse
B. Drej
NL
A. Verplaats de hefboom
totdat deze vergrendelt.
B. Verdraai het geheel
SE
A. Flytta spak för att låsa
B. Snurra
549-527
(pcb retaining arm and sponge plate
546-281
546-297
546-354
Note: To complete the assembly, the user will need to have a p.c.b
retaining arm and sponge plate, a p.c.b. holder and one of the
bases.
Assembly instructions
Assembly the retaining arm and p.c.b. holder such that the clamp fits
on the stem of the holder with the frame guide located in the slot (figure
1). The stem of the holder will then fit into any of the bases RS stock
no. 546-281/297.
Working instructions
The retainer/holder assembly can be swivelled on the ball joint of the
base so that a p.c.b. may be fitted to the holder and components fitted
as shown in figure 2.
Place the sponge plate over the components and hold it down firmly.*
Bring the retaining arm down against the back of the plate and lock it in
position by moving the locking lever towards the plate (see figure 3).
The sponge plate and p.c.b. assembly in the holder may be swivelled
to expose the other side of the board (figure 3) ready for soldering and
cropping. Extract the p.c.b. after releasing the locking lever and
removing the sponge pate.
*Figure 4 shows a cross-section of the sponge plate holding
components to a p.c.b. where individual rectangular sections in the
sponge hold components of different height more effectively.
RS Components shall not be liable for any liability or loss of any nature (howsoever
caused and whether or not due to RS Components' negligence) which may result
from the use of any information provided in RS technical literature.
RS Stock No.
(bench top/clamp bases)
(bench top/clamp bases)
(pcb holder)
Publicidad
