Angelcare AC115 El Manual Del Propietario página 12

SET THE TIC FUNCTION
Allows you to detect baby's movements as well as hear a TIC sound.
IMPORTANT
To activate the ''TIC'' Function, the movement detection activated.
TO TEST THE SENSOR PAD
MOVEMENT FUNCTION NEEDS TO BE ACTIVATED:
1
MOVEMENT ALARM
• If NO movement is detected after 15 seconds you will hear
a single "TIC" pre-alarm sound from the Nursery Unit.
• If after a further 5 seconds there is still NO movement
detected on the surface of the mattress, the Parent Unit
and Nursery Unit will emit loud continuous beeps
- this is the Movement Alarm.
• Nursery Unit light will flash red.
• Sensor Pad Icon and sound level bar on Parent Unit will flash.
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Adjust Sensor Pad sensitivity level.
• Turn OFF crib mobile, fans, loud music or anything else that may cause vibration.
12
2
2
1) Press and HOLD the MENU Button then press
the OK button until the "TIC"
2) Use the UP and DOWN arrows to activate or
deactivate the TIC function.
3) Press the OK button to go to the next setting
or press the EXIT button to confirm your
choice.
1) Move your hand lightly on the mattress.
NOTE:
The Parent Unit will emit a
"TIC" sound (when activated) and will flash
every 5 seconds.
2) Remove your hand from the mattress.
After 15 seconds you will hear a
"TIC" pre-alarm sound, and 5 seconds
later the Movement Alarm will trigger.
3) Repeat by moving your hand lightly
in all four corners of the mattress.
icon blinks.