Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Display Installation -
9. Select the depth of the phillips screws M4 x 12mm (15)
or M4 x 25mm (16) relative to mounting holes in the back of
display. Place the VESA bracket (7) on the back of display.
Align the mounting holes with the screw inserts. Once the
VESA bracket is in position, carefully tighten the four screws
until the VESA bracket is firmly attached to display monitor.
Attaching Display
10. Take off the cover of LCD column (1), and insert display monitor
with VESA bracket from top down into the LCD column.
Cover
1
Remove gas spring
tension retaining
screw
A
Mobile Sit and Stand Workstation
WARNING! A CPU should be mounted to the cart before displays are mounted.
12. After final assembly, remove the gas spring tension
retaining screws as shown in Fig. (A) and (B) below. Pull the
lever up to change the work surface to desired height.
All labels must
be on the same
side as the label
at the base.
Mobile Base
Stop immediately if you encounter any resistance, or you
may damage your monitor.
before the mount is firmly attached, you may need to use
a shallower depth screw or spacers.
monitor's operation manual. Note: oval spacers (17) may be
used for curved or other type of display monitors.
7
15
16
17
11. Once the display assembly is in position, tighten screws at both
ends of VESA bracket with 3mm allen wrench (18) clockwise and put
the cover back on the top of LCD column.
Under Work Surface
5
Assembly Instructions
If you encounter resistance
Please consult your
8. Put fixed plate (8) onto
VESA bracket.
18
Remove gas
spring tension
retaining
screw
B
8
Publicidad
Tabla de contenido
