HDS Systems BR11066 Manual Del Propietário página 6

Installation
AIR VALVE REPLACEMENT
Hazardous Pressure. To be sure air
valve and core cannot blow out of tank, release all
air pressure from tank before removing valve core
or valve.
1. Disconnect power to pump.
2. Drain ALL water in system by opening faucet
closest to tank.
3. Depress valve core to release ALL air pressure
in tank. When air stops coming out of valve,
remove core from inside of valve to release
remaining pressure.
4. Push air valve back into tank. Be sure to remove
it before reassembling tank.
5. Disconnect piping from tank and turn it on
its side.
6. Remove flange from tank.
7. Push water cell into tank far enough so that you
can get into tank with a dowel rod.
8. Soap the outside of the new valve and mount it
on the end of a piece of 1/4" or 5/16" dowel
rod. Push the valve up past the water cell into
its mounting hole in the top of the tank. Push it
through as far as it will conveniently go; leave
the valve cap on to protect the threads on
the valve.
SUBMERSIBLE AND MULTI-STAGE INSTALLATIONS
Tank with Submersible Pump
Pressure
Pressure
Gauge
Switch
From Well
160 0893
PIPING CONNECTIONS
NOTE: When using metal pipe with plastic fittings use only
Teflon tape or Plasto-Joint Stik on male threads.
To service
Pressure
Relief Valve
9. Rap the end of the dowel sharply with a
hammer to drive the valve into position. Be sure
the shoulder on the valve seats against the tank
head (the ridge around the valve body should
be all the way through the hole in the tank
head – see Figure 6).
10. Remove the dowel. Make sure the old valve has
been removed from the tank, pull water cell
back over rim of hole in lower tank head,
reinstall flange, stand tank upright and
reconnect piping.
11. Recharge tank (see Page 4), turn on power, fill
system, and tank is ready for service.
Figure 6 – Tap valve into place
Tank with Multi-Stage Pump
Pressure
Relief Valve
To Service
6
2869 0697