Evolution 005-0001 Instrucciones Originales página 4

IMPORTANT
Please read these operating and safety instructions
carefully and completely.
For your own safety, if you are uncertain about
any aspect of using this equipment please access
the relevant Technical Helpline, the number of
which can be found on the Evolution Power Tools
website. We operate several Helplines throughout
our worldwide organization, but Technical help is
also available from your supplier.
CONTACT:
Web:
www.evolutionpowertools.com
UK/EU/AUS:
customer.services@evolutionpowertools.com
USA:
evolutioninfo@evolutionpowertools.com
GENERAL SAFETY INSTRUCTIONS
Read these instructions before using this mitre
saw stand. Do not modify or use this stand for
any purpose other than that for which it was
designed.
• Keep work area clear of obstructions and
well ventilated. Clutter makes accidents
more likely.
• Consider the work area environment. Do
not use power tools in damp or wet conditions.
Keep the work area well lit.
Do not use power tools in the presence
of flammable liquids or gases.
• Keep children and bystanders away.
Visitors are a distraction and are difficult
to protect and are unlikely to have any
knowledge of safety procedures.
• Store idle equipment. Preferably in a locked
dry cupboard.
• Safety Glasses. Approved safety glasses
should be worn by the operator and any
assistants when using a mitre saw.
• Stay alert. A moments inattention when
operating power tools may result in serious
personal injury. Do not use if tired or under the
influence of drugs, alcohol or medication.
• Do not overreach. Keep proper footing and
balance at all times.
STAND SPECIFIC SAFETY
INSTRUCTIONS
• For maximum stability use the mitre stand
only on a flat, level surface.
• Be careful when raising or lowering the stand
to prevent trapped fingers or hands.
www.evolutionpowertools.com
• Ensure that the snap buttons on each leg are
in the locked position. This will ensure that the
stand remains rigid during cutting operations.
• Do not step or climb on the stand.
• Before operation ensure that the mitre saw
is securely fastened to the stand to prevent
unwanted movement of the saw.
• Ensure that the material supports are locked in
place before use.
• Do not overload the side extension arms.
• Do not use if the stand becomes damaged
in any way.
DEPLOYING THE LEGS
PRIOR TO ASSEMBLY
Note: It is much easier to set up or knock down
the stand without a saw being attached.
• Push the locking/unlocking button
(Fig. 1) and deploy all 4 legs, ensuring they are
locked in their service position.
ASSEMBLY INSTRUCTIONS
• Screw the long locking screws (D) into the
guides. (Fig. 2)
• Slide the work support brackets (C) onto the
extension arms and lock in place with a long
locking screw (D). (Fig. 3)
• Insert the work support roller (B) into the
bracket and lock in place using a long locking
screw. (D) (Fig. 4)
For Normal Cutting Operations:
• The top of the roller(s) should be level with the
surface of the Mitre Saws rotary table.
• The extension arm(s) should be positioned be
give maximum support to the workpiece.
For Repetitive Cutting Operations:
• The 'stop face' (Fig. 4a) can be positioned at
the required distance from the saw blade.
• The required work support should be adjusted
so that the 'stop shelf' (Fig. 4b)
is level with the Mitre Saws rotary table and
facing towards the saw.
• Adjust the relevant extension arm until the
'stop face' is at the required distance.
CHECKING AND ADJUSTING THE SAW
MOUNTING BRACKET CLAMPING
PRESSURE
The pressure exerted by the clamping mechanism
within a saw mounting bracket can be adjusted.
The clamping pressure of each bracket should
be checked before it is attached to a mitre saw.
When fitted across the mitre saw stands two main
4