Motor Unit - Philips HR1720/50 Manual De Instrucciones

EnglisH
8
Disassembling the blender
1 Unplug the appliance.
 Remove the lid with the measuring cup from the blender jar.
 Remove the blender jar with the blade unit attached to it from the motor unit.
 Always clean the removable parts immediately after use.
tips
- If you want to crush ice cubes, put not more than 6 ice cubes (of approx. 24x35x25mm) in the
blender jar and turn the control knob to pulse position a few times.
- Cut meat or other solid ingredients into smaller pieces before putting them in the blender jar.
- Do not process a large quantity of solid ingredients at the same time. To get good results, we
advise you to process these ingredients in a series of small batches.
- To make tomato juice, cut the tomatoes in four and drop the pieces through the opening in the
lid onto the rotating blades.
cleaning
We advise you to clean the removable parts immediately after use.
Always unplug the appliance before cleaning.
Never clean the motor unit, the blade units, the filter and the sealing rings in the dishwasher.
,
Always disassemble all removable parts before cleaning them. Do not forget to remove the
,
sealing rings from the blade units (blender and mill).
Avoid touching the blades. The blades are very sharp.
,
The blender and mill jar (without blade unit), lid and measuring cup are dishwasher-proof.

Motor unit

Clean the motor unit with a moist cloth. Do not rinse the motor unit under the tap. Do not
,
use abrasives, scourers, alcohol, etc.
Blender
1 Assemble the blender jar (see chapter 'Using the appliance').
 Pour lukewarm water and some detergent into the blender jar.
 Place the lid on the blender jar and insert the measuring cup into the hole in the lid.
 Plug in the appliance.
5 Put the blender jar onto the motor unit (see chapter 'Using the appliance')
6 Switch the appliance on and let it run for a few seconds.
7 Switch off and unplug the appliance.
8 Remove the blender jar from the motor unit, take off the lid and rinse the blender jar with
clean water.
storage
You can store excess mains cord by winding it round the base of the motor unit.
Environment
Do not throw the appliance away with the normal household waste at the end of its life, but
,
hand it in at an official collection point for recycling. By doing this you will help to preserve
the environment. (Fig. 7)