Important - Yardworks 060-1803-0 Manual Del Propietário

Drive Pedal
The drive pedal is located on the right side of the
tractor, along the running board. Depress the
drive pedal forward and the tractor will move in
the direction that the shift lever is engaged in.
To cause the tractor to travel forward, while at
a complete stop, move the shift lever into the
Forward position. Gradually step on the drive
pedal and the tractor will begin to move forward.
To move in Reverse, follow the same procedure
only move the shift lever into the reverse position.
The ground speed is controlled with the drive
pedal. The further forward that the pedal is
pivoted, the faster the tractor will travel. The pedal will return
to its original position when it's not depressed. Refer to the
Operation section of this manual for detailed instructions
regarding the drive pedal.

IMPORTANT:

Always set the parking brake when leaving the
tractor unattended.
Deck Lift Lever
Found on your tractor's right fender, the deck lift lever
is used to change the height of the cutting deck. To use,
move the lever to the left, then place in the notch best
suited for your application.
PTO (Blade Engage) Lever
Found on the tractor's right fender, the PTO (blade engage)
lever is used to engage power to the cutting deck. To
operate, move the lever all the way forward. Moving
the lever all the way rearward into the PTO OFF position
disengages power to the cutting deck.
NOTE: The PTO (blade engage) lever must be in the
disengaged (PTO OFF) position when starting the engine.
S
ection
4 — c & F
ontrolS eatureS
15