HAMPTON BAY 52144 Guía De Uso Y Mantenimiento página 8

Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock, or other
personal injury, mount the fan to an outlet box marked
"Acceptable for fan support of 35 lbs (15.9 kg) or less" and
use the mounting screws provided with the outlet box.
NOTE: The mounting bracket (A) is designed to slide into place
on an outlet box with the outlet box screws (JJ).
□
Pass the 120-Volt supply wires through the center hole in the
slide-on mounting bracket (A).
□
Install the ceiling slide-on mounting bracket (A) on the outlet
box by sliding the slide-on mounting bracket (A) over the two
screws (JJ) provided with the outlet box. If necessary, use leveling
washers (not included) between the slide-on mounting bracket
(A) and the outlet box. Note that the flat side of the slide-on
mounting bracket (A) is toward the outlet box.
□
Securely tighten the two outlet box screws (JJ).
JJ
2
□
□
JJ
A
8
Hanging the fan
WARNING: When using the standard ball/downrod mounting,
the tab in the ring at the bottom of the mounting bracket
must rest in the groove of the hanger ball. Failure to properly
seat the tab in the groove may result in fan wobble issues
and potentially damage the wiring.
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
Seat the hanger ball portion of the ball/downrod assembly (D)
in the mounting bracket socket. Ensure that the tab on the
slide-on mounting bracket (A) socket is properly seated in the
groove in the hanger ball.
A
D
E