Sanus MF209 Manual De Instrucciones página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
2
Wall Mounting - Wood Stud
For assitance in determining wall plate location, see Height Finder at sanus.com.
2-1
Locate stud
< 16 mm
(5/8 in.)
2-2
Level wall plate [02] and mark hole locations
2-3
Drill pilot holes as illustrated
2-4
Tighten lag bolts [23] only until the washers [24] are pulled fi rmly against the wall plate [02]
[24]
[23]
8
Verify the center of the stud using an awl, a thin nail, or an edge to edge stud
fi nder.
TV will shift 15 cm (6 in.) to the right or left when in the home position.
Consider this when selecting the location of your wall mount.
[02]
bolt. To avoid potential injuries or property damage: pilot holes MUST be
drilled to a depth of 75 mm (3 in.), using a 5.5 mm (7/32 in.) diameter drill
bit.
75 mm
3 in.
bolt. To avoid potential injuries or property damage DO NOT over-tighten
the lag bolts [23].
Fit lag bolt covers [26] over lag bolts [23].
[02]
[24]
CAUTION:
Avoid potential personal injuries and property damage!
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 2 x 4 in (nominal 1.5 x 3.5 in).
NOTE:
The MF209 is shown.
NOTE: For the MF209 only:
CAUTION:
Improper use could reduce the holding power of the lag
CAUTION:
Improper use could reduce the holding power of the lag
NOTE: The MF209 is shown.
[23]
[26]
13mm
5.5mm
(1/2 in.)
(7/32 in.)
6901-002129 <02>

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mf215

Tabla de contenido