Scott ALPRIDE AIRBAG SYSTEM 2.0 Manual De Usuario página 8

STEP 17
Load the device by screwing
the tool clockwise to the
very end.
IMPORTANT NOTES
DO NOT TWIST THE AIRBAG
DO NOT CROSS THE HOOKS
DO NOT BLOCK THE AIRBAG
SCOTT Sports SA shall not be liable for any damages and losses due to incorrect reloading.
HOW TO ADJUST THE TRIGGER HANDLE
STEP 1
Adjust the height of the trigger handle on the shoulder strap. There
are three different settings (S/M/L).
The trigger handle should ideally be at chest height.
• 7. MAINTENANCE
7.1. POST-AVALANCHE CHECK
Every use of the SCOTT ALPRIDE AIRBAG SYSTEM can negatively affect the material. Often the damage is not visible
with the naked eye. After a use in an avalanche, contact the authorized SCOTT Dealer where you have bought your SCOTT
ALPRIDE AIRBAG SYSTEM for further inspection.
If you are unable to send the SCOTT ALPRIDE AIRBAG SYSTEM, then following points are recommended to check :
1- Check the airbags visually for punctures
2- Check the airbag fastening straps for tears
3- Check the shoulder, waist and chest straps as well as the seams for tears
4- Check all buckles (adjustment buckles at the shoulder straps, waist and chest strap)
5- Check buckles as well as leg straps for tears and deformation
ENGLISH -8
STEP 18
Unscrew the tool. System is
ready to use if the red pin has
disappeared.
DO NOT FOLD THE AIRBAG
DO NOT ROLL THE AIRBAG
TO DEFLATE THE AIRBAG, USE THE SCREW
ONLY (NOT A SCREW DRIVER OR A PEN).
FULL?
STEP 19
Screw the new cartridges.
MAKE SURE THE STRAP IS ALWAYS
WELL TIGHTENED.
STEP 2
Turn up the trigger handle to
change the height position.
STEP 20
Close the cartridges
compartment.
STEP 3
Then slide the trigger handle
out of the webbing loop
according and slide it back in
the correct height.