Troubleshooting - Levolor Sheer Shadings Instalación

OPERATION

Troubleshooting

Troubleshooting
Problem The shading will not snap into the installation brackets.
Solution Check that the installation brackets are aligned and level.
Check that the locking lever on the installation bracket slides
over the headrail.
Problem The shading is hard to raise or lower, or the bottom rail does not stop at
the top limit.
Solution Check the adjustment position of
ALL limit stops. The top illustration
shows the correct adjustment. The
limit stop catches the bottom rail,
and the bottom of the limit stop is
slightly above or barely touching
the fabric roll.
In the second illustration, the limit
stop adjustment is too tight. The
fabric may not drop freely and could
even be damaged when the shading
is raised. To correct this, the limit
stop should be adjusted one step
up. Simply pull back on the rear of
the limit stop to adjust its position.
In the bottom illustration, the
adjustment is too loose. The bottom
rail can slip under the limit stop. If
the bottom rail rotates through the
headrail, it must be backed out
before adjusting the limit stop.
IMPORTANT: ALL limit stops must
be adjusted to the same position or
else skewing may occur.
12
Cordless Operating System
20-0037-012_Sheer_Shadings_Cordless_F_010621.indd 12-13
Headrail Limit Stop
Headrail Limit Stop
Headrail Limit Stop
Bottom
Bottom
Rail
Rail
Bottom
Fabric Roll
Fabric Roll
Rail
Fabric Roll
Pull Back
Pull Back
to Adjust
to Adjust
Pull Back
to Adjust
Too Tight —
Too Tight —
Adjust One Step Up
Adjust One Step Up
Too Tight —
Adjust One Step Up
Pull Back
Pull Back
to Adjust
to Adjust
Pull Back
to Adjust
Too Loose —
Too Loose —
Adjust One Step Down
Adjust One Step Down
Too Loose —
Adjust One Step Down
Troubleshooting
Problem The shading is hard to raise or lower, or will not raise or lower.
Solution Shadings cannot be forced into tight inside mount window
openings. If an inside mount, check that the shading is installed
correctly. Make sure there is clearance between the ends of the
shading and the window casement.
Check that the installation brackets are level. Shim to level,
if necessary.
Check that the shading fabric is not catching on any brackets or
window components.
Problem The shading raises or lowers unevenly, the fabric rubs against one end of
the headrail, or the bottom rail is uneven when fully raised.
Solution Check that the window is square by measuring the diagonals.
Check that the installation brackets are level. Shim to level,
if necessary.
Adjust the bottom rail weight. See below.
Adjusting the Bottom Rail Weight
• Release the weight clips by inserting
a flat head screwdriver into the weight
clip and turning clockwise.
Weight
Clip
• Move the weight in 1" increments toward the side where the
fabric is gathering.
• Secure the weight clips in position by turning them counterclockwise
after making the adjustment.
• Test and, if necessary, adjust again.
OPERATION
Weight
Bottom Rail
Clip
Weight
Fabric Roll
Gathered
Fabric
Move Weight
13
Cordless Operating System
1/6/21 4:48 PM