Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000344-001.book Page 17 Tuesday, February 11, 2020 11:46 AM
Working instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
For each job, use only the FEIN application tool released and intended for the respective
application.
Switching on and off (figure 5).
Check the power supply cable
WARNING
and the plug for damage.
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
Switching on:
Press the On/Off switch and the lock-off at
the same time.
Release the lock-off.
Switching off:
Release the On/Off switch.
Locking on:
While the power tool is switched on, press
and hold the lock-off and release the switch.
To disengage, press the switch again and then
release it.
Keep the mains cable away from rotating
application tools. When losing control
over the machine, the mains cable can be
cut through or get caught, and your hand or
arm can come in contact with the rotating
application tool.
Do not overload the power tool!
Move the power tool back and forth applying
uniform pressure, so that the work piece sur-
face does not become too hot.
Fig. 5
Lock-off
On/Off switch
en
17
Publicidad
