Functions For The Turnout Decoder - marklin 24802 Manual De Instrucciones

Putting track together
Taking track
apart
Turnout decoders are already built into the turnouts. These can
be operated digitally.
The turnout decoder for the right turnout is preset at MM-/DCC-
Address 5 and the turnout decoder for the left turnout is preset
at MM-/DCC-Address 6.
The procedure for controlling the turnouts digitally can be
found in the operating instructions for your digital controller.
8
A selection of controllers can be found on Page 28. The turnout
decoder addresses can be changed if desired. See Page 30 to
do this.

7. Functions for the Turnout Decoder

• Capable of multi-protocols: fx (MM) and DCC
• Mode of operation set with DIP switches
• Addresses can be set with DIP switches:
1-256 fx (MM) (Control Unit 6021/Mobile Station
60651/60652)
1-320 fx (MM) (Central Station 602xx/Mobile Station
60653/60657)
1-511 (DCC)
• Programmable addresses using CVs
1-2,044 DCC
• Changes to characteristics can be done with CVs
• Digital signal: transfer independent of the power supply
• Power supply done using the digital power circuit
• Alternative power supply
• Solder pads for connections for turnout lanterns
• Turnout lanterns can be turned on or off