Stinger WD20250 Manual Del Propietário página 3

Maintenance
Filter
Your filter should be cleaned often to
maintain peak Vac performance.
NOTE: The filter is made of high quality
material designed to stop small particles
such as sawdust. Handle the filter carefully
when removing to clean or installing a new
filter. Do not tear the filter during removal
or installation if your intent is to reuse the
filter.
Easy to Replace Filter
1. Extend the retainer band around the
plastic posts on the lid.
2. Remove filter bag off the filter cage.
3. Place the replacement filter on the filter
cage until open end touches bottom of
lid.
4. Release the retainer band from the
plastic post on the lid, holding the filter
bag secure to the lid.
5. Make sure the retainer band is
positioned on the filter bag covering the
black printed line.
Retainer
Band
Lid
Power Head
(upside-down)
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the Vac for dry
material pick-up.
Take the dirty filter to a disposal container
and gently brush away small dirt particles
that may be adhering to the filter material.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small
hole can allow a lot of dust to come out of
your Vac. Replace it immediately.
Installation
Before installing the filter on the Vac, clean
the area of the lid so that the retainer band
will seal the bag against the lid and stop
small particles from bypassing the filter
bag.
If the filter is clean and not damaged,
replace it on the filter cage. If it cannot be
reused, place a new filter over the filter
cage.
Replace the retainer band around the
filter. Make sure the retainer band is
positioned on the filter, and the filter
completely covers the filter cage. Also,
make sure the edges of the filter are
completely secured under the retainer
band.
NOTE: Clean the filter in an open area.
Cleaning should be done outdoors and not
in the living quarters.
filter cage and float. The float
prevents liquid from entering the
impeller and damaging the motor.
Plastic
The cage prevents fingers from
Post
touching the moving impeller.
10
WARNING: Do not remove the