HAMPTON BAY HB-7779-02 Guía De Uso Y Cuidado página 6

Installation (continued)
6
Testing the motion sensor alert
and doorbell
In most cases, testing of the motion sensor requires two
people; one person to activate the motion sensor (C) and
the other to listen for the doorbell to sound.
□
Slide the ON-TIME switch to the "TEST"
position.
□
Temporarily position the motion sensor (C) near
the desired mounting location.
□
While someone is listening for the doorbell (A)
to sound, walk in front of the motion sensor (C).
The red LED on the motion sensor (C) should
flash and the doorbell (A) will sound "Beep-
Beep". In the "TEST" position, all motion
must stop for 10 seconds before the motion
sensor (C) will activate the doorbell (A) again.
□
If the doorbell (A) does not sound, move the
doorbell (A) closer to the motion sensor (C) and
test again.
7
Testing the doorbell and door
alert placement
□
Temporarily position the door alert (D) and
magnet (E) where they will be mounted.
□
Move the magnet (E) away from the door
alert (D) to simulate a door being opened. The
red LED should flash and the doorbell (A) will
sound "Beep-Beep".
□
If the doorbell does not sound, move the
doorbell closer to the door alert and test again.
8
Mounting the doorbell
IMPORTANT: Do not permanently mount the doorbell or any of the
transmitters until the doorbell and all of the transmitters are working
together properly.
Use the screws (DD) to mount the doorbell (A).
□
Mark two level points 2.75 in. apart on the
mounting surface. Drill two 3/16 in. pilot holes
and insert the wall anchors (EE). Insert the
screws (DD) into the wall anchors (EE) leaving
about 1/8 in. of the screw threads exposed.
Hang the doorbell (A) on the screws (DD) using
the keyholes on the back of the doorbell (A).
NOTE: Do not permanently mount the motion sensor until
the motion sensor and doorbell are working properly.
MAX
SYNC
RANGE
MAX MIN
TEST 1 5
(MINS)
SYNC
ON-TIME
C
NOTE: Do not permanently mount the door alert until the
doorbell and door alert are working properly.
D
E
NOTE: This doorbell is designed to either hang vertically
or horizontally.
"C" 1.5V
6
RANGE
MIN
TEST 1 5
(MINS)
ON-TIME
C
A
EE
DD
A
A