HAMPTON BAY HB-7779-02 Guía De Uso Y Cuidado página 7

Installation (continued)
9
Mounting the push button
Use either screws (BB) or double-sided tape (FF) to
mount the push button (B).
□
To mount with screws (BB), remove the back
of the push button (B) by pushing in the tab
on the bottom with a small screwdriver. Place
the push button (B) back on the door jamb
and mark the two screw holes. Attach with
screws (BB) and snap on the front of the push
button (B).
□
When attaching the push button (B) with
double-sided tape (FF), remove paper from
both sides of the double-sided tape (FF) and
apply to a clean surface.
10
Mounting the motion sensor
Attach the motion sensor (C) mounting bracket to
a sturdy surface using screws (BB). Make sure the
motion sensor (C) has an unobstructed view.
□
Place the motion sensor (C) mounting bracket
in the desired location and mark the two screw
holes. Attach with screws (BB).
□
If the motion sensor (C) was removed from the
mounting bracket, use a Phillips screwdriver
(not included) to loosen the clamp screw on
the mounting bracket. Insert the swivel ball
on the motion sensor (C) into the mounting
bracket until it snaps into place. Aim the
motion sensor (C) toward the area to be
monitored and tighten the clamp screw.
11
Preparing to mount the door
alert
The maximum gap between the door alert (D) and the
magnet (E) is 1/2 in.. The arrows on the face of each
component must be aligned and facing each other.
□
Place the door alert (D) on the door frame and
the magnet (E) beside the door alert (D) and
ensure the arrows are aligned.
□
If the magnet (E) is recessed, use the
spacer (F) to ensure proper alignment.
NOTE: Attach the mounting bracket vertically when
attaching to a curved surface.
IMPORTANT: The motion sensor must be rotated so the controls
are facing down.
BB
E
1/2" Maximum
7
Please contact 1-844-760-3644 for further assistance.
BB
C
D
F
D
HAMPTONBAY.com
E