Handle Installation - American Standard Patience TU106500 Instrucciones De Instalación

2
STANDARD WALL INSTALLATION
• Figure 1. Remove plaster guard from valve. Push CAP (1)
over VALVE CARTRIDGE (2) until seated against stop.
• Figure 2. Push ESCUTCHEON (3) onto CAP (1) and attach
to valve body with LONG SCREWS (4).
THIN WALL INSTALLATION
• Figure 1a. Push CAP (1) over VALVE CARTRIDGE (2) until
seated against stop.
• Figure 2a. Push ESCUTCHEON (3) onto CAP (1) and attach
to valve body with LONG SCREWS (4).
PLASTER
GUARD
Figure 1.
Figure 1a.
3
INSTALL TUB SPOUT, SHOWER HEAD,
SHOWER ARM WITH FLANGE
Protect finish on SHOWER HEAD
CAUTION
and TUB SPOUT when installing.
• Remove pipe cap and plug from shower and tub
rough piping.
• Slip DECORATIVE PLATE (5), then slip TUB SPOUT (1) onto tub
nipple and tighten with 4mm Hex Wrench.
CAUTION: Protect finish on TUB SPOUT when installing.
• Install SHOWER ESCUTCHEON (2) onto SHOWERARM (3). Apply
sealant or Teflon tape to threads on both ends of SHOWER ARM (3)
and thread longer leg of SHOWER ARM (3) into shower elbow.
• Thread SHOWER HEAD (4) onto SHOWER ARM (3).
CAUTION: Protect finish on SHOWER HEAD and ARM when
installing.
4

HANDLE INSTALLATION

• Hold ADAPTER (4) onto CARTRIDGE STEM (2) and install ADAPTER SCREW (5)
through ADAPTER (4) into CARTRIDGE STEM (2). Tighten ADAPTER SCREW
(5) to secure ADAPTER (4) to CARTRIDGE STEM (2).
• Install HANDLE (1) by pushing it onto CARTRIDGE STEM (2) and tightening SET
SCREW (3) from below with 2.5 mm Hex Wrench supplied.
1
2
2
1
4
- 2 -
1
Figure 2.
1
Figure 2a.
2
4
PIPE
CAP
5
1
1
3
4
3
4
SHR.
ELBOW
PIPE
PLUG
3
TUB FILLER
NIPPLE
.
E F
" R
1 / 2
1 -
2.5 MM HEX
WRENCH
2
4
5
3
2.5MM HEX
WRENCH
M965929 Rev. 1.0 (12/18)