Publicidad
Idiomas disponibles
Idiomas disponibles
Consequently warranty replacements become difficult to recognise
because damages can occur due to a bad mounting.
To avoid this situation and to grant a right assembling and
disassembling of these SAC clutches, it is necessary to use a special
tool.
DISMOUNTING
The usage of this special clutch tool is basic also to dismount SAC
clutches. In fact if we try to dismount a SAC clutch, the clutch will
unadjust, causing problems during mounting operations, have a
shorter life and cause a lot of vibrations.
Follow these instructions:
• Mount the handle into the main threaded shaft, locking the
picture 1.
• Unscrew the 3 screws at 120° (or 4 screws at 90°
fig. 2).
• Mount the suitable screws M6 or M7 or M8 (legs) supplied in
this set (fig. 3 and 4);
• Install the special clamp tool (3 or 4 shanks) and lock it with the
M8 locking knobs
• Rotate the special tool's handle to compress the cup spring
totally (fig. 5).
• Unscrew now the remaining flywheel locking screws (fig. 6).
• Remove the M8 locking knobs from the special tool, then the
special tool and the three legs.
• Now the pressure plate is raised and the clutch bell touches the
flywheel, becoming easy to unscrew and remove the clutch (fig.
7).
MOUNTING
• Put the plate and the clutch mechanism on the flywheel;
• Centre the disk clutch using one of the suitable tool supplied (fig.
8 - 9 - 10 - 11).
• Insert the three legs with the right threading but do not tighten,
otherwise you can damage the SAC system.
14
3
4
5
6
Publicidad
