Configuration - LEGRAND 288 12 Manual De Instrucciones

Ocultar thumbs Ver también para 288 12:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 5
GB:
Description
Item 288 12 is a programmable electronic device capable of controlling 6 relay outputs. The device can work in three different ways, depending on
the product it is associated to, or if used as with supervision system device. Communication is ensured by the Modbus protocol.
1
Power supply 24V~/
2
Power supply 24V~/
Note:
use power supplies with double insulation or equivalent
+
Tx/Rx RS485
-
Tx/Rx RS485
SG
Signal mass
6 NO/NC relay outputs, contacts 230 V~, 8 A

Configuration

A1-3 – Modbus Address.
The Modbus address is defined by configuring the first three positions.
Each of these can be worth "no configurator" = 0, 1 ÷ 9*.
The address value (in decimal, values allowed 1÷247) is obtained as
follows:
A1 x 100 + A2 x 10 + A3
Example:
A1=2, A2=3, A3= "no configurator":
the address value is 230.
* Configurators: item(s). 0 492 00/09
M – Modbus Transmission mode.
The transmission mode is defined as follows:
- 1
- "no configurator"
ASCII mode
"default" (RTU mode)
B – Modbus Transmission Speed.
The transmission speed is defined as follows:
- 1
- 2
- 3
- 4
- 5
- 6
- "no configurator"
F – Operation mode.
The additional functionalities are defined as follow:
- 1
- "no configurator"
Communication characteristics
Parity: none (not configurable)
Stop bit: 1 (not configurable)
3
4÷6 mm
0,75 ... 1,5 mm
0,75 ... 1,5 mm
0,75 ... 1,5 mm
2,5 mm - 0,3 Nm
1,2kbit/s
2,4kbit/s
4,8kbit/s
9,6kbit/s
19,2kbit/s
38,4kbit/s
"default" (speed 19,2 kbit/s)
"default" (Contact repetition side-by-side
3
with DMX
circuit-breaker)
Use with supervision system
2
2
2

Publicidad

Tabla de contenido
loading

Tabla de contenido