Air Conditioner Use; Air Conditioner Care; Cleaning; Air Filters - Haier HPP08XCR Instrucciones De Instalación Y Manual Del Usuario

AIR CONDITIONER USE

IMPORTANT: If the air conditioner has been tilted on its
side, wait 24 hours before turning on the air conditioner
to allow the oil to return to the compressor. This will
prevent the air conditioner from failing prematurely.
•
Allow 20" (51 cm) of space around the unit for proper air
circulation.
•
Do Not operate the air conditioner without air filters in
place.
•
Do not spill liquid on the control panel; it may cause an
electrical short to the interior electronic parts that would
either disable them or cause them to function
improperly.
•
When turning on the air conditioner for the first time
after plugging it into an electrical outlet, the unit will start
in Cooling mode set at 75ºF (24°C), and at High fan speed.
The control panel will display the current room
temperature.

AIR CONDITIONER CARE

WARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Failure to do so can result in death or electrical shock.

CLEANING

1. Unplug or disconnect power.
2. Use only a soft cloth dampened with water to clean the
cabinet.
NOTE:
•
Do not use a liquid or spray cleaner to clean the
air conditioner.
•
DO NOT use chemicals, abrasives, ammonia,
chlorine bleach, concentrated detergents,
solvents or scouring pads. Some of these
chemicals/items may damage and/or discolor
your air conditioner.
3. Dry thoroughly with a soft cloth.
4. Plug in or reconnect power.

AIR FILTERS

The air filters should be cleaned at least once a week for your
unit to operate at optimum efficiency.
IMPORTANT: Do Not operate the air conditioner without
air filters in place.
•
When turning on the unit after previous use, it will
remember the last settings used.
•
After a normal shut down, please wait for 3 minutes
before restarting the unit.
•
In Cooling mode, this unit should not require water to be
removed. This model has a unique design that
continuously evaporates the water.
•
When the unit is operated in high humidity conditions,
you may need to empty the water tank periodically.
•
The unit will shut down automatically when the water
tank is full. The Water Full indicator illuminates to alert
you of this condition.
1. Unplug or disconnect power.
2. Pull on the tabs to slide out the filters from the back of
the air conditioner.
NOTE: The secondary filters are accessible once
the main filters are removed.
3. Wash or vacuum the dust from the air filters.
NOTE: If washed, gently shake the filter to remove
the excess water and dust particles trapped in the
filter.
4. Reinstall the filters.
5. Plug in or reconnect power.

INTERNAL WATER TANK

The Water Full indicator illuminates, when the internal water
tank has filled with condensed water.
To Empty the Internal Water Tank:
1. Unplug or disconnect power.
2. Place a shallow 1 quart or larger pan (not included) below
the lower drain located on the back (near the bottom) of
the air conditioner.
3. Remove the cap and the rubber plug and drain the water
tank.
4. Re-insert the drain plug and screw the cap snugly into
place.
5. Plug in or reconnect power.
9