Uline OHAUS DEFENDER 5000 XTREME Manual Del Usuario página 6

7. The display flashes the actual difference between
the calibration data and the test weight.
8. The example shows a 0.010
kg difference. The result of the
calibration test is printed.
9. After 5 seconds, calibration test
ends and the scale returns to
the active weighing mode and
displays the current weight.
ZERO OPERATION
Zero can be set under the following conditions:
• Automatically at power on
(initial zero).
• Semi-automatically (manually) by
pressing the ON/ZERO OFF button
• Semi-automatically by sending the zero command
(Z or alternate zero command).
Press the ON/ZERO OFF button to zero the weight display.
The scale must be stable to accept zero operation.
MANUAL TARE
When weighing an item that must be
held in a container, taring stores the
container weight in memory.
1. Place the empty container on the
scale (example 0.5 kg) and press
the TARE button. The display will
show the net weight.
2. To clear the tare value, empty the
scale and press the TARE button.
The display will show the gross
weight.
PRE-SET TARE
A pre-set tare (PT) is a known tare
value entered using the xT command
(example 1.234 kg). The display will
show the pre-set tare as a negative
value with the PT Indicator on.
• The PT value will supersede any other tare or PT
value in memory.
• When using pre-set tare, make sure that auto-tare
function is set off in the Setup Menu.
• If the tare entry includes digits beyond the
readability of the Indicator, the tare value is
rounded off to the readability of the Indicator.
To clear a pre-set tare value, empty the scale, then
press the TARE button. The display will show the gross
weight.
PAGE 6 OF 30
OPERATION CONTINUED
AUTO-TARE
Auto-Tare automatically tares the initial weight (such as
a container) placed on the empty scale, without having
to press the TARE button. The tare value is cleared
0.010
kg
automatically when the weight on the scale is fully
removed.
. 30.010
During checkweighing operation, if the On Accept
kg
setting is selected in the Setup Menu, weight values that
are within the accept range will be tared automatically.
CHANGING UNITS OF MEASURE
 . O.000
1.
kg
PRINTING DATA
Printing the displayed data to a printer or sending the
data to a computer requires that the communication
parameters in the Print and Communication Menu are set.
1.
. 0.500
kg
APPLICATION MODES
1.
. O.000
NET kg
WEIGHING
O.000
kg
*
Place the item to be weighed on
G
the scale. The illustration indicates a
sample of 1.5 kg (gross weight).

PARTS COUNTING
Use this mode to count parts of uniform
weight. The Indicator determines the
quantity based on the average weight
of a single part. All parts must be
uniform in weight for accurate measurements.
NOTE: Auto-Tare supersedes any PT value in
memory.
Press and hold the PRINT UNITS button until the
desired measuring unit appears. Only measuring
units enabled in the Unit Menu will be displayed.
Press the PRINT UNITS button to send the displayed
data to the communication port (the Auto-Print
Mode function must be off).
Press and hold the FUNCTION MODE button until the
desired application mode appears. Only modes
enabled in the mode menu will be displayed.
NOTE: Press the FUNCTION
MODE button to temporarily
display the weight in 10x
expanded resolution.
WEIGH
. 1.500
kg
. 1.5000
kg
COUNt
0615 IH-4595