SMA NR-STP-BFS.BG4 Manual De Instrucciones página 13

SMA Solar Technology AG
8. Pull the DC load-break switch down and out of the
recess.
9. Remove all 6 screws from the lower enclosure lid
using an Allen key (AF 3).
10. Lift and remove the lower enclosure lid from below.
11.
Risk of burns when touching the enclosure parts
The enclosure parts become hot during operation. Touching these components can cause
burns.
• After switching off the inverter, wait until any hot enclosure parts have cooled down
before touching them.
12. Note the position of the DC connector in order to be able to connect it again later in the same
position.
Replacement Manual
5 Disconnecting the Inverter from Voltage Sources
CAUTION
BFS-STPTLEE-10-RM-xx-10 13