Pump Reassembly - Parts2o FPP1511 Manual De Instrucciones

INSTALLING NEW SEAL (continued)
4. If seal does not seat correctly after
recleaning cavity, place a cardboard
washer over polished seal face and
carefully press into place using a
piece of standard 3/4" pipe as a
press.
IMPORTANT: Be sure you do not
scratch seal face.
5. Dispose of cardboard washer and
recheck seal face to be sure it is
free of dirt, foreign particles,
scratches, and grease.
6. Inspect shaft to be sure it is free of
nicks and scratches.
7. Reassemble pump body half to
motor flange. Be sure it is right
side up.
8. Apply liquid soap sparingly (one
drop is sufficient) to inside diameter
of rotating seal member.
9. Slide rotating seal member (carbon
face first) onto shaft until rubber
drive ring hits shaft shoulder (See
Figure 8).
Be Careful
...Does Not
That Motor
Damage Seal Face
Shaft Shoulder...
Ceramic
Carbon
Face
Face
Figure 8
IMPORTANT: Be sure not to nick or
scratch carbon face of seal when pass-
ing it over threaded shaft end or shaft
shoulder. The carbon surface must
remain clean or short seal life will result.
Pump Brand
FPP1511
Flotec FP4301, FP4312
Simer 3305
Seal and Gasket Kit FPP1500 works with all models listed above.
10. Hold motor shaft with 7/16" open
end wrench on shaft flats and screw
impeller onto shaft (See Figure 9).
Be sure you do not touch capacitor
terminals with body or any metal
object. Tightening impeller will
automatically locate seal in correct
position.
Figure 9
11. Remount diffuser on pump body
half with five screws.
12. Follow instructions under "Pump
Reassembly".

PUMP REASSEMBLY

1. Clean O-ring and O-ring groove.
2. Put O-ring in groove on face of
flange; put pump halves together
(See Figure 10).
Figure 10
For Use With Kit No.:
FPP1512 FPP1513
FP4322 FP4322
3307 3310
2
3. BE SURE inside of clamp is clean.
Place clamp on pump halves; snug
up. Alternately tighten screw and
tap clamp with mallet to seat O-ring
(See Figure 11). Replace base
mounting bolts.
Figure 11
4. Replace pressure switch tubing and
motor wiring; replace drainplug.
5. Prime pump according to instruc-
tions. See "Operation".
6. Check for leaks.