Manufacturer's Warranty - Hilti IC-BLE Manual De Instrucciones Original

Trouble or fault
LED does not light up when
the operating button is
pressed
LED does not light up (control
switch set to AUTO)
Vacuum cleaner does not
start and/or does not react to
inputs via the remote control
unit
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
11 FCC statement (applicable in US) / IC statement (applicable in Canada)
This device has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules. These limits are intended to ensure adequate protection against
electromagnetic interference when the device is operated in areas used for commercial purposes.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause interference to radio communications. The user must
bear costs incurred due to interference that operation of this device in residential areas can cause.
This device is in compliance with paragraph 15 of the FCC rules and the RSS­210 specifications of ISED.
Operation is subject to the following two conditions:
• This device shall cause no harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by Hilti may restrict the user's authorization to
operate the equipment.
14 English
Possible cause
Button-cell battery discharged
Remote control unit faulty
Cable of the receiver module not
correctly plugged into the vacuum
cleaner
Receiver module not correctly in-
stalled
Receiver module faulty
Button-cell battery discharged
No connection between receiver
module and remote control unit
Pairing procedure was aborted or
failed
Source of trouble is in the vacuum
cleaner
Action to be taken
▶ Change the battery in the
remote control unit. → page 13
▶ Contact Hilti Service.
▶ Check that plug connection and
cable are correctly installed and
check for faults.
▶ Install the receiver module on
the vacuum cleaner. → page 12
▶ Contact Hilti Service.
▶ Change the battery in the
remote control unit. → page 13
▶ Make sure that remote control
unit and receiver module are
paired.
▶ Pair the remote control unit
with the receiver module again.
→ page 12
▶ Repeat the pairing procedure
→ page 12.
▶ Read the instructions in the
troubleshooting section of the
operating instructions for the
vacuum cleaner.
2321964
*2321964*