Ampro NEO FLEX TRUSS Manual De Usuario página 10

Led par 3-in-1 rgb 3w
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7. MAINTENANCE AND CLEAN-
ING THE UNIT
Make sure the area below the installation place is
free from unwanted persons during setup.
Switch off the unit, unplug the main cable and wait
until the unit had cooled down.
All screws used for installing the device and any
of its parts should be tightly fastened and should
not be corroded.
Housings, fixations and installation spots (ceilling,
trusses, suspensions) should be totally free from
any deformation.
The main cables must be in impeccable condition
and should be replaced immediately even when a
small problem is detected.
It is recommended to clean the front at regular
intervals, from impurities caused by dust, smoke
or other particles to ensure that the light is radi-
ated at maximum brightness. For cleaning, discon-
nect the main plug from the socket. Use a soft,
clean cloth moistened with a mild detergent. Then
carefully wipe the part dry. For cleaning other
housing parts use only a soft, clean cloth. Never
use a liquid, it might penetrate the unit and cause
damage to it.
FUSE REPLACEMENT
1.
Remove the safety cap by a screwdriver.
2.
Replace the blown fuse with a fuse of the exact
same type and rating (T2A-250V).
3.
Install the safety cap, and reconnect power.
P. 10
NEO FLEX TRUSS
ENGLISH VERSION

Publicidad

Tabla de contenido
loading

Tabla de contenido