Amana HTK530 Serie Instrucciones De Instalación página 4

underneath handle and snapping bottom in place.
A — Freezer door
B — Freezer handle
C — Handle insert
10. Align freezer door right side trim. After checking
placement, peel off paper backing and press trim in
place. Freezer door right side trim will be cupped on
bottom end only.
11. Install freezer trim plug by placing in left side top
freezer door hole.
12. Align freezer door top trim. After checking place-
ment, peel off paper backing and press trim in
place. Cupped end of trim should be opposite hinge.
13. Install freezer door by setting on bottom right
hinge pin.
14. Install center hinge pin and door closure.
15. Install new top hinge bracket on top right of
refrigerator by installing rear screws loosely with a 8
mm hex nut driver. Set refrigerator door on door
closure. Install remaining screws and tighten all
screws. Verify handle side of door is approximately
3 mm higher than hinge side. Door lowers when
loaded with food and when panel is installed.
16. Install new top hinge cover with screw using a
Phillips screwdriver.
17. Install refrigerator door extension with 13 mm
screws using Phillips screwdriver as shown.
A — Right hinge application
B — Refrigeratior door extension
C — Left hinge application
18. Align refrigerator door right side trim. After check-
ing placement, peel off paper backing and press
trim in place. Refrigerator door right side trim has
notched flanged end on top and cupped end on
bottom.
19. Install refrigerator door top trim with 6 mm screws
using a Phillips screwdriver. Flange end of trim is
handle side, cupped end of trim is hinge side.
20. Install freezer door decorator panel by sliding in
from left side of freezer door.
21. Align freezer door left side trim. After checking
placement, peel off paper backing and press trim in
place. Freezer door left side trim is cupped on both
ends.
22. Install refrigerator door decorator panel by sliding in
from left side of door.
23. Install new refrigerator door handle on left side with
screws in lower holes in handle with a Phillips
screwdriver.
A — Handle
B — Screws
C — Trim
24. Install refrigerator door left side trim by removing
tape backing and placing over refrigerator door
handle. Left side trim will be cupped at both ends.
4