Eu Declaration Of Conformity; Warranty - AL-KO Easy Crush MH 2800 Instrucciones De Uso

EU declaration of conformity

If you encounter any malfunctions that are not listed in this table or which you cannot rectify
yourself, please contact our responsible customer service.
EU DECLARATION OF CONFORMITY
We hereby declare that this product in the version introduced into trade by us, complies with the requirements of the harmonised EU Di-
rectives, EU safety standards and the product-specific standards.
Product
Blade shredders
Type
Easy Crush MH 2800
Serial number
G2052056
Sound power level
measured / guaranteed
102 / 104 dB(A)
Named position
Société Nationale de Certification et
d'Homologation
2a Kalchesbruck
L-1852 Luxembourg

WARRANTY

If any material or manufacturing defects are found during the statutory customer protection period, we
will either repair or replace the equipment, whichever we consider the more appropriate. This statutory
period may vary according to the legislation in force in the country where the equipment was purchased.
Our warranty is valid only if:
The equipment has been used properly
The operating instructions have been followed
Genuine replacement parts have been used
The following are not covered by warranty:
Paint damage due to normal wear
Wear parts identified by a border [xxx xxx (x)] on the spare parts list
Combustion motors (these are covered by a separate warranty from the manufacturer concerned)
The warranty period begins on the purchase by the first end user. Decisive is the date on the receipt.
To make a claim under warranty, please take this statement of warranty and proof of purchase to the
nearest authorised customer service centre. This warranty does not affect the usual statutory rights of
the customer relative to the seller.
440565_a
Manufacturer
AL-KO Geräte GmbH
Ichenhauser Str. 14
D-89359 Kötz
EU Directives
2006/42/EC
2000/14/EC
2004/108/EC
2006/95/EC
Conformity evaluation
2000/14/EC
Appendix V
The warranty is no longer valid if:
The equipment has been tampered with
Technical modifications have been made
The equipment was not used for its intended
purpose
Duly authorised person
Anton Eberle
Ichenhauser Str. 14
D-89359 Kötz
Harmonised standards
DIN EN 55014-1:2012-05
DIN EN 55014-2:2009-06
DIN EN 13683:2003 + A2:2011
DIN EN 62233:2009-04
DIN EN 60335-1:2010
DIN EN 61000-3-2:2010
DIN EN 61000-3-11:2010
Fpr EN 50434:2009
Antonio De Filippo
Managing Director
Kötz, 01.03.2013
21