Publicidad
Idiomas disponibles
Idiomas disponibles
The water flow to the brushes can be regulated
via a ball valve.
Water is applied to the brushes at an angle from
above, through 3 holes on each side.
The soles and sides of boots can be cleaned
using the 3 stationary brushes.
Pay attention to adopting a stable position during
use, and make use of the integrated handle.
4. Environmental factors
The boot cleaner ECO should not be exposed to
direct sunlight for extended periods.
Excessive heating can result in deformation
of the brushes.
Suitable usage conditions are max. -10 °C to
+40 °C.
If there is a risk of frost, disconnect the boot
cleaner from the water supply, and empty it.
5. Accessories / Spare parts
Replacement brush set
for stationery brushes (3 pieces)
Item. No. 232.0009.011
Scraper grate for coarse dirt
Order code 10589
Accessories: Scraper grate
6. Maintenance
Dirty parts can be washed down with water
and a hand brush.
The dirt that accumulates beneath the boot
cleaner can be flushed away with water.
Worn brushes can be removed and replaced
via the four screws on each brush.
7. Warranty
Under our general terms and conditions of trade
we warrant that the boot cleaner ECO will be pro-
duced free from defects in materials, functionality
or workmanship. These are available at
http://cemo.de/agb.html
The warranty applies only under the condition
that the above operating instructions, and all
applicable regulations, are closely followed.
GB
5
Publicidad
