DMS
700
Antenna Indication
Status & Warning
Messages
Status messages
in order of priority:
12
6 Display
The DSR 700 receiver is a special digital true-diversity design with an integrated antenna splitter. The
antenna field (H) indicates the active antenna.
The status and warning indication function provides visual warnings to alert you when selectable crit-
ical system conditions occur. If one of the selected conditions occurs, the LED ring (11) around the
SELECT control will change from green to red and a warning message will appear on the display that
describes the current fault condition. The warning messages appear in the order of priority.
Depending on the type of warning, a large message (upper field) is shown permanently or for 5 secs.
A small message (bottom line) is displayed for as long as the warning is not confirmed. The selected
warning functions are active in LOCK and ACTIVE modes.
• To delete a warning message from the display, press the SELECT control briefly.
1. LOW BATT: Transmitter battery capacity is low. The LED ring is
lit red and a large warning message displayed permanently.
2. AF CLIP: Audio overload in transmitter A/D converter. The LED
ring is lit red and a large warning message displayed for 5 secs.
or as long as the fault condition lasts.
A small warning message is displayed in the main window until
the warning is confirmed.
3. RF LOW: The field strength of the received RF signal is too low,
the receiver's audio output is muted to prevent unwanted noise.
The LED ring is lit red and a large warning message displayed for
5 secs. or as long as the fault condition lasts.
A small warning message is displayed in the main window until
the warning is confirmed.
4. ANT ERROR: The same antenna has been active for more than
one minute. The LED ring is lit red and a large warning message
displayed for 5 secs. or as long as the fault condition lasts.
A small warning message is displayed in the main window until
the warning is confirmed.