Olivetti ECR 5200 Guía De Referencia Rápida página 5

5. CHANGE THE DECIMAL POINT POSITION
The decimal point setting is preset to the x.xx format. This format can be changed, as needed, to one of the other
settings below.
1. Open the printer compartment cover and slide the control switch to the PRG position.
2. Type [1] followed by the status number [0, 1, 2 or 3] to select the desired format as indicated in the following
table:
Status Number
0
1
2
3
3. Press the [RA/ ] key to set the new format.
4. Program another feature or exit the program mode by sliding the control switch to the OFF position.
Example: Program the cash register so that two digits are left after the decimal point.
Type/Press:
[1] + [2] + [RA/ ]
6. LINK A MULTIPLE/SINGLE ITEM SALE, TAX STATUS AND ITEM PRICE TO A
DEPARTMENT
Programming a department consists of assigning a multiple/single item sale and a tax status to it. You can then
optionally assign a preset price to the department. A 3-digit department status can be programmed by using the
following options:
Multiple/Single Item Sales
0 = Multiple Item Sales
1 = Single Item Sales
1. Open the printer compartment cover and slide the control switch to the PRG position.
2. Type the [Multiple/Single Item Sales] and [Tax Status] options by referring to the previous table. A 3-digit status
code must be entered.
3. Press the [Check] key to confirm your entry.
4. Type a [price] to assign to a specific item and then press the relative [Department] key.
5. Program another feature or exit the program mode by sliding the control switch to the OFF position.
Example: Program a multiple item sale, VAT3 and a price of £2.50 to an item in Department 2.
Type/Press:
[0] + [0] + [3] + [Check] + [250] + [Department 2/8]
Format
x
x.x
x.xx
x.xxx
Tax Status
00 = Non taxable
01 = Taxable with VAT1
02 = Taxable with VAT2
03 = Taxable with VAT3
04 = Taxable with VAT4
3