Publicidad
Idiomas disponibles
Idiomas disponibles
12. Remove fluid nozzle after removing from the fluid needle group or keep it held in order to protect
the seat section.
CAUTION: If any of the following signs appear during operation, stop the device immediately,
otherwise it could originate serious personal injuries. Only a qualified person and an authorized service
center can carry or any repair or replacement of pieces from this device.
Disconnect the air supply from the device before any service procedure is carried out.
Sign
Undulation or
Spitting while spraying
The finish is arch shape
The finish is not sprayed
evenly.
The finish center is very
narrow.
The finish width is fan shape.
Distribuzione Ferritalia Soc. Coop.
Via Longhin, 71 – 35129 Padova
Italy
Problem
The pack set of the needle is
dry or eroded allowing air to
enter the flow.
There is a spillage between the
top joint and the material
container.
There is spillage in the needle
pack.
Dirt or strange elements in the
air obstruct the holes in the
end.
Volume is odd from the fluid
end causing its deviation.
There is material in the central
hole of the nozzle end or the
nozzle
hole
is
obstructed.
There is a spillage in the
nozzle.
Atomization pressure is very
high.
Very thin material.
Atomization pressure is too
low.
Very thick material.
6
Tighten it or replace it.
Tighten it
Tighten it or repare it.
Remove the obstruction from
the holes in the end or
immerse it in solvent and then
dry it and clean it.
Remove the obstruction, never
use hard elements for its
partially
renoval.
Tighten it.
Reduce air pressure.
Regulate material viscosity.
Increase air pressure.
Regulate material viscosity.
Solution
Publicidad
