Practical Advice; Maintenance And Cleaning - Yamato MICRO Manual De Instrucciones

cod. 95056-91843-91844-91846-91847
glue from the skin.
Use only glues recommended by the manufacturer of the Glue gun.
Bonded connections can loosen under the effect of moisture.
Preparation for Gluing
The surfaces to be glued must be clean,dry and free of grease.
The materials to be glued as well as the surface on which you are working may not be easily ignitable or
inflammable. Check the suitability of heat-sensitive materials first on a test workpiece.
The ambient temperature and the workpieces to be glued may not be colder than +5℃ and warmer than
+50℃.
Materials, such as metal, which cool off the glue quickly, should be preheated with a hot air gun.
Gluing
• Insert the appropriate glue stick (6) for the material being glued via the opening at the rear of the Glue gun.
• Switch the Glue gun on and allow it to heat up
• Press the feed trigger applying moderate pressure.
• Apply the glue only on one side
• After applying the glue, immediately press the surface to be glued together. Correcting the gluing location is
still possible at the point.
The glued spot can be subjected to load after a cool-down period of approx. 5 minutes.

Practical Advice

Material/Workpiece Recommendation
Large-surfaces, long work pieces
Flexible materials (e.g. textiles)
Remove glue residue after cooling with a blunt object. If re-quired, glued spots can be separated again by
applying heat.
• Do not use inflammable solvents for cleaning the surfaces to be glued.
Solvent remainders can ignite from the hot glue, or hazardous vapours can develop.
Glue remainders on clothing cannot be removed.
Glued spots can be painted.

Maintenance and Cleaning

• Warning! Before any maintenance or cleaning, switch the Glue gun off.
• For safe and proper working, always keep the Glue gun clean.
An inserted glue stick may not be removed out of the rear opening of the glue gun.
If the Glue gun and the charger should fail despite the care taken in manufacture and testing, repair should be
carried out by an authorised customer service agent from power tools.
After excess glue has hardened, it can be removed with a blunt object. Do not use solvent for cleaning.
Information on disposal for users of waste electrical & electronic equipment.
This symbol on the products and/or accompanying documents means that used electrical and
electronic products should not be mixed with general household waste. For proper treatment,
recovery and recycling, please take these products to designated collection points, where they will be
accepted on a free of charge basis. Disposing of these products correctly will help to save valuable
resources and prevent any potential negative effects on human health and the environment which could
otherwise arise from inappropriate waste handling. Please contact your local authority for further details of your
nearest designated collection point.
Apply the glue in the form of points
Apply the glue in lines