Power Supply; Battery Operation; Setting Time; Setting The Alarm - Blaupunkt BSD-9000 Manual Del Usuario

User manual

POWER SUPPLY

This set operates on AC 230~ 50Hz or 4 x 1.5 V R20/UM1/"D"size batteries (not provided).
AC operation
Connect the detachable AC cord (included) to the AC socket on the rear of the unit. Insert the AC power cord into a
convenient standard AC wall outlet.
Caution!
- The set must be disconnected from the mains to operate on batteries.
- When the set is connected to the mains, the power source automatically switches to AC.

Battery operation

1. Remove the lid of the battery compartment by sliding it outward in the direction of the arrow.
2. Insert 4 R20/UM1/"D"size batteries into the compartment. Make sure to match their polarities (+/-) to the markings
inside the compartment.
3. Put the lid back in place.
Note:
-The AC cord must be unplugged from both the socket on the unit and the power outlet for the unit to run on the
batteries.
- When the set is connected to the mains, the power source automatically switches to AC.
- The appearance of battery icon "
Notes on batteries (not supplied)
·Do not mix different types of batteries or old batteries with new ones.
·Never recharge the batteries, apply heat to them or take them apart.
·Batteries should not be exposed to excessive heat such as sunshine, fire or the like.
·Do not throw the batteries in fire!
·Attention should be drawn to the environmental aspects of battery disposal.
·The batteries need to be replaced when: The volume decreases, or sound is distorted during operation.
·In order to avoid leakage, remove the batteries when unit will not be used for a long period of time.
·Please respect the environment. Before throwing any batteries away, consult your distributor who may be able to take
them back for specific recycling.
Caution!
Danger of explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type.

SETTING TIME

After the batteries are installed, the display will show "0:00".
1. Press MEMO once to enter time setting mode. The display will show flashing "24 HOUR". Then press TUNING
to select 24H or 12H time format.
2. Press MEMO again to confirm and the hour digits flash.
3. Press TUNING
4. Press TUNING

SETTING THE ALARM

Set alarm time
In Standby mode, long press ALARM button until "ALARM" indicator displays and hour digits flash on display.
2. Press TUNING
3. Press TUNING
Set wake up source
Press ALARM repeatedly to select the wake up source among "
• Wake to the buzzer sound
displays and buzzer sound will come out when the alarm time is reached.
• Wake to the radio
1. Follow procedures in "Listen to the radio" to select your desired radio station and adjust the alarm sound level.
2. displays and radio sound will come out when the alarm time is reached.
Checking Wake Time
Long press ALARM until you see a flashing wake time.
" on display indicates that the batteries are low. Replace them with new batteries.
to set the hour value. Press MEMO to confirm and minute digits flash.
to set the minute value and press MEMO again to confirm.
to adjust hour value. Then press ALARM to confirm and minute digits flash.
to adjust minute value and press ALARM to confirm.
" and " ".
BSD-9000 / BSD-9001
8